Velocity Hunter 430 Bedienungsanleitung

1 OPERATION MANUAL VELOCITY 1995 Hunter 430 OWNER/HOSTS Kirk and Lisa Knudsen Mount Vernon. WA

10 The HOUSE BATTERY BANK provides power for all DC systems. When disconnected from shore power, all 12-volt devices and 110-volt devices drain the

11 the PUMP LEVER to the ‘right’ (dry bowl). Pump to remove water from the bowl. Flush sufficiently to move effluent in the hoses; heavy effluent m

12 To operate the macerator, open the OVERBOARD THRU-HULL for the appropriate tank (fwd or aft). The aft THRU-HULL is located under an access pane

13 Fresh Water Pressure Pump The WATER PRESSURE PUMP is located under galley seat at aft end. Activate pump at the DC panel by turning on the breake

14 couple sec to warms up. When finished cooking turn off the switches and the bottle. Refrigeration

15 Two 120-volt SPACE HEATERS are available when connected to shore power. Both can be found in under the seat in the aft stateroom. FOR BACKUP USE

16 ANCHORING The primary WORKING ANCHOR is a 45lb. CQR anchor and is attached to 250 ft. chain passed through the deck from the ANCHOR L

17 starboard chock bring the end of the line back through the port side. You will essentially create a bridle with about 10 feet of slack from the c

18 Note: Propane bottles are not stocked by AYC. You will need to purchase one if extras are not found on board. Caution -- For safety reasons, d

2 Welcome aboard! We are happy you have chosen Velocity for your vacation. Velocity is a Hunter 430. She was commissioned in Seattle in 1995 and h

3 VELOCITY 1995 HunTEr 430 L.O.A 42’ 6” Displacement 23,800 Lbs. L.W.L 38’ Ballast 7,600 Lbs. BEAM 14’ Sail Area

4 TABLE OF CONTENTS Page Boat Operation Engine Inspection 5 Start-Up 6 Shutdown 6 Ge

5 Sails/Furling Systems 17 Barbecue 17 Dinghy 18 Other: Safety/Bilge Pumps 18 Boat Oper

6 Using higher throttle settings will produce very little increase in forward speed but will greatly increase fuel and oil consumption and the wear

7 Switch off the key after engine has completely stopped. Push the engine stop back in after the engine stops or the engine will not restart. Get

8 Pumping too fast may not allow enough time for air to escape, which may result in spouting from the tank opening. As the tank fills, the sound w

9 At the ELECTRICAL PANEL, flip the AC CURCUIT BREAKER on. Check for reverse polarity. Then turn on appropriate breakers for water heater,