Velocity V50 Bedienerhandbuch PDF herunterladen (Seite 5)

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USE

When using your new iron, basic safety precautions should always be followed,

including the following:

1. Use iron only for its intended use.

2. To protect against a risk of electric shock, do not immerse the iron in water

or other liquids.

3. The iron should always be turned to «Off» before plugging or unplugging

from an outlet. Never yank the cord to disconnect from the outlet. Instead,

grasp the plug and pull to disconnect.

4. Do not allow the cord to touch hot surfaces. Let the iron cool completely

before putting away. Loop cord loosely around the iron when storing.

5. It is always recommended to disconnect the iron from the electrical outlet

when ﬁlling with water or emptying. It should also be disconnected when

not in use.

6. Do not operate the iron with a damaged cord or if the iron has been dropped

or damaged. To avoid the risk of an electric shock, do not disassemble the

iron. Take it to a qualiﬁed service depot for examination and repair. Incorrect

reassembly can cause a risk of electric shock when the iron is used.

7. Close supervision is necessary for any appliance being used by or near children.

Do not leave the iron unattended while connected or on an ironing board.

8. Burns can occur from touching hot metal parts, hot water, or steam. Use

caution when you turn a steam iron upside down – there may be hot water in

the reservoir.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high wattage appliance

on the same circuit.

2. If an extension cord is absolutely necessary, a 15-amp cord should be used.

Cords rated for less amperage may overheat. Care should be taken to arrange

the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS IN A SAFE

PLACE FOR FUTURE REFERENCE

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Velocity V50 Bedienerhandbuch Seite 5