Velocity Edge GX325 Bedienungsanleitung PDF herunterladen (Seite 13)

Plate Hole Designation for UX, SX,

GC and GF Series

As shown in Figure 14, the pierced holes at the corners of the

plate are designated as: 1 for upper right, 2 for lower right, 3 for

lower left and 4 for upper left when facing the gasketed side of

the plate. Plates 1 and 2 in Figure 14 are represented as A1234

and B1234 respectively. Plates with all four holes pierced can also

be designated with a blank space or an *. Unpierced ports will

be represented as a zero (0). For example, Plate 3 is represented

by a A1004 since there are no holes at position 2 and 3. Table

8 shows A and B equivalents when an “A” plate is rotated to

become a “B” plate.

Make sure the gaskets are installed correctly in relation to the

ﬂ ow directors. (See Figures 15 and 16.)

Figure 14

Hole designations.

Figure 15

Correct gasket location.

Figure 16

Incorrect gasket location.

Chevrons point

up on “A” plates

and down on

“B” plates

NOTE: Flow

directors as related

to “A” and “B”

plates

Chevrons point

up on “A” plates

and down on

“B” plates

NOTE: Flow

directors as related

to “A” and “B”

plates

“A” Plate

“B” Plate

“A” Plate “B” Plate

Porthole designations shown apply to all units purchased

after June 1, 2002. Refer to unit drawing or previous

IOM (SC-10M-9) for older UX, SX, S, GF or TW Series.

“A” Plate “B” Plate “A” Plate “B” Plate

1234 1234 0204 0204

1034 1230 0034 1200

1204 0234 1200 0034

0234 1204 0004 0200

1230 1034 1000 0030

1004 0230 0030 1000

0230 1004 0200 0004

1030 1030 0000 0000

Table 4

“A” and “B” Equivalents

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Velocity Edge GX325 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für PC / Workstation Barebones Velocity Edge GX325